3D Wilson Transfer System

_3D^®_{TRANSFER SYSTEM}


	Office procedure 1. Using light tray wax (fig.1) the inserts are place in the tubes(fig.2) in the patients mouth and picked up in a impression
	2. Note the protruding posts from the Wilson inserts(fig.3).
	3. With a sharp scalpel, remove 3mm of impression material, lingual to the posts for seating clearance.
	4. Seat the 3D Transfer Lingual tubes on the protruding posts. If necessary, contour the retaining tab of the 3d transfer tube to insure retention in the stone model (fig. 2). 5. Add sticky wax over the 3D^® Lingual tubes and fill the space between the tubes and impression material (fig 3).
	6. Pour with stone and separate. The 3D^® Transfer Lingual tubes will be accurately positioned and securely attached to the stone model.
	7 Proceed to fabricate the 3D^® appliance on the stone model or send to the lab to have fabricated 6. Store the model against future breakage and rescue the Inserts from the impression material to autoclave.